Français
English
40Pin Jumper Wire Connection Line Breadboard Jumper Cable Arduino DIY Kit 20 CM
350,00 DA
| Taille | F/F, M/F, M/M |
|---|
Produits connexes
MODULE compatible Arduino to control 4 motors DC or 2 stepper motors and have 2 connections for servomotors. This shield uses pins D3 to D12 for operation (direction, speed, etc).
The module is based on two L293D drivers and can control up to 4 DC motors with an intensity of 0.6 A per output (1.2 A at peak).
Shaft support diameter 16 mm – SK16
The shaft can be tightened with an M5 screw provided.
V-Slot is a high quality linear rail profile made of aluminium with an extremely smooth V-groove on the 4 sides. It is accurate, easy to work with and allows you unlimited design control by its modular nature.
Shaft support diameter 10 mm – SK10
The shaft can be tightened with an M5 screw provided.
- ESP32-WROVER is a powerful, generic WiFi-BT-BLE MCU module that targets a wide variety of applications,ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streamingand MP3 decoding. The ESP32-WROVER has two versions: The ESP32-WROVER IPEX Module uses an IPEX antenna while the ESP32-WROVER PCB module has a PCB antenna.
Shaft support diameter 08 mm – SK08
The shaft can be tightened with an M5 screw provided.
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.
