Français
English
40Pin Jumper Wire Connection Line Breadboard Jumper Cable Arduino DIY Kit 20 CM
350,00 DA
| Taille | F/F, M/F, M/M |
|---|
Produits connexes
Shaft support diameter 08 mm – SK08
The shaft can be tightened with an M5 screw provided.
Stepper motor 28BY J-48 with Driver ULN2003
the ULN2003 stepper motor driver or in English stepper motor, unipolar (4 phases/ 5 wires ) allows you to easily plug the small motor 28BY J-48 5v gràce to the 5 pin male connector and connects easily to an arduino or other through a 4 pin connector for control signals and Gnd (ground/-). The power supply of ULN2003 is between 5 and 12V.
Transceiver module based on an NRF24L01 allowing a 2.4 GHz wireless connection. This module communicates with an Arduino or compatible microcontroller via the SPI bus.
- ESP32-WROVER is a powerful, generic WiFi-BT-BLE MCU module that targets a wide variety of applications,ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streamingand MP3 decoding. The ESP32-WROVER has two versions: The ESP32-WROVER IPEX Module uses an IPEX antenna while the ESP32-WROVER PCB module has a PCB antenna.
Shaft support diameter 12 mm – SK12
The shaft can be tightened with an M5 screw provided.
The SG90 servo motor is a type of continuous rotation motor controlled by a digital signal. It is used in projects such as robotics, position control systems, and DIY projects.
V-Slot is a high quality linear rail profile made of aluminium with an extremely smooth V-groove on the 4 sides. It is accurate, easy to work with and allows you unlimited design control by its modular nature.
