Français
English
40Pin Jumper Wire Connection Line Breadboard Jumper Cable Arduino DIY Kit 20 CM
350,00 DA
| Taille | F/F, M/F, M/M |
|---|
Produits connexes
cnc drill bit set, cnc drill, pcb drill,Cheap cnc drill bit set,High Quality cnc drill, China pcb drill Suppliers
10 Pcs 0.3mm-1.2mm Carbide micro PCB Drill Bits Print Circuit Board Mini CNC Drilling Bit Set pcb drills
Efficiently Working Device
The TL-Smoother is a module that can be added to stepper motor drivers (A4988, DRV8825, etc.) that are utilized in 3D printers and CNC.
Its role is to reduce vibrations, ripples and mechanical noise generated by stepper motors, smoothing the electrical signal transmitted to the motor coils.
This module improves print quality, reduces ghosting/moiré phenomena on printed parts and extends the mechanical life of motors.
Stepper motor 28BY J-48 with Driver ULN2003
the ULN2003 stepper motor driver or in English stepper motor, unipolar (4 phases/ 5 wires ) allows you to easily plug the small motor 28BY J-48 5v gràce to the 5 pin male connector and connects easily to an arduino or other through a 4 pin connector for control signals and Gnd (ground/-). The power supply of ULN2003 is between 5 and 12V.
A 5v relay is an automatic switch that is commonly used in an automatic control circuit and to control a high-current using a low-current signal. The input voltage of the relay signal ranges from 0 to 5V.
Transceiver module based on an NRF24L01 allowing a 2.4 GHz wireless connection. This module communicates with an Arduino or compatible microcontroller via the SPI bus.
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.
Shaft support diameter 08 mm – SK08
The shaft can be tightened with an M5 screw provided.
