Français
English
Produits connexes
This is a general OLED display Module, 0.91inch diagonal, 128×32 pixels, with embedded controller, communicating via I2C interface.
MODULE compatible Arduino to control 4 motors DC or 2 stepper motors and have 2 connections for servomotors. This shield uses pins D3 to D12 for operation (direction, speed, etc).
The module is based on two L293D drivers and can control up to 4 DC motors with an intensity of 0.6 A per output (1.2 A at peak).
Shaft support diameter 10 mm – SK10
The shaft can be tightened with an M5 screw provided.
Arduino Nano has enough processing power to control many electronic components. It has several I/O pins, which allows to connect it to many components. , it is a compact and reduced version of Arduino uno maroc.
Arduino Nano has 14 digital inputs/types (6 of which can be used as PWM outputs), 8 analog inputs.
Stepper motor 28BY J-48 with Driver ULN2003
the ULN2003 stepper motor driver or in English stepper motor, unipolar (4 phases/ 5 wires ) allows you to easily plug the small motor 28BY J-48 5v gràce to the 5 pin male connector and connects easily to an arduino or other through a 4 pin connector for control signals and Gnd (ground/-). The power supply of ULN2003 is between 5 and 12V.
This stainless steel precision cutting pliers will allow you to precisely cut your Karthala, fiber, cotton, non-resistive thread… But also to finalize the assembly of your reconstructable atomizers.
The head of this cutter is isolated from the rest of the body and its blades are inclined for more precision
A 5v relay is an automatic switch that is commonly used in an automatic control circuit and to control a high-current using a low-current signal. The input voltage of the relay signal ranges from 0 to 5V.
Shaft support diameter 08 mm – SK08
The shaft can be tightened with an M5 screw provided.
Shaft support diameter 16 mm – SK16
The shaft can be tightened with an M5 screw provided.
