Français
English
0.91 inch OLED module White OLED 128X32
This is a general OLED display Module, 0.91inch diagonal, 128×32 pixels, with embedded controller, communicating via I2C interface.
FEATURES:
- 0.91inch small form factor
- 128×32 high resolution
- I2C interface, requires only two signal pins
SPECIFICATION:
- Driver: 1306
- Interface: I2C
- Display color: White
- Resolution: 128×32
- Viewing angle: >160°
- Operating voltage: 3.3V / 5V
- Dimension: 36 x 12.5 (mm)
Produits connexes
The SHT3x sensor is the most accurate and precise sensor for measuring humidity and temperature parameters compared to other temperature sensors like LM35, Thermistor, DS18B20 & DHT11/DHT22. Thus SHT3x can be used for industrial applications because of the high accuracy and good sensitivity. Its Relative Humidity operating range is 0 – 100% and Temperature operating range is -40° to +125°C (-40° to +257°F).
Shaft support diameter 10 mm – SK10
The shaft can be tightened with an M5 screw provided.
This stainless steel precision cutting pliers will allow you to precisely cut your Karthala, fiber, cotton, non-resistive thread… But also to finalize the assembly of your reconstructable atomizers.
The head of this cutter is isolated from the rest of the body and its blades are inclined for more precision
The MQ3 analog gas sensor is suitable for detecting alcohol; this sensor can be used in a breathalyzer.
It has high sensitivity to alcohol and low sensitivity to gasoline.
The sensitivity can be adjusted using a potentiometer.
The TL-Smoother is a module that can be added to stepper motor drivers (A4988, DRV8825, etc.) that are utilized in 3D printers and CNC.
Its role is to reduce vibrations, ripples and mechanical noise generated by stepper motors, smoothing the electrical signal transmitted to the motor coils.
This module improves print quality, reduces ghosting/moiré phenomena on printed parts and extends the mechanical life of motors.
- ESP32-WROVER is a powerful, generic WiFi-BT-BLE MCU module that targets a wide variety of applications,ranging from low-power sensor networks to the most demanding tasks, such as voice encoding, music streamingand MP3 decoding. The ESP32-WROVER has two versions: The ESP32-WROVER IPEX Module uses an IPEX antenna while the ESP32-WROVER PCB module has a PCB antenna.
The Arduino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 15 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.
